Suitable for 80-1 6-hole centrifuge

Description

Suitable for 80-1 6-hole centrifuge
Low speed desktop centrifuge instruction manual
First, the product introduction:
The desktop centrifuge is a routine laboratory instrument used in scientific research, education and production departments such as biology, chemistry, and medicine. The low-speed tabletop centrifugal maximum speed is 4000r/min, which is suitable for radioimmunoassay and separation of cells and large particles, both timing and non-time.
Third, safety instructions:
1. If the power indicator light is off when the power is turned on, stop it immediately.
2. It is strictly forbidden to run without load when the rotor is not installed.
3. Check the rotor for corrosion damage before running.
4. Do not open the centrifuge cover while the rotor is running. Do not touch the running rotor.
5. It is strictly forbidden to run the rotor under unbalanced loading conditions.
Fourth, the use of instructions:
1: The working table of the centrifuge should be flat and firm, the work room should be neat and clean, dry and well ventilated, and the ambient temperature should be 5prefix = st1 ns = "urn:schemas-microsoft-com:office:smarttags"-32°C.
2: Turn on the external power supply, close the power switch, and the indicator light is on.
3: Turn off the power switch.
4: Open the centrifuge cover and wipe the inner cavity and rotor.
5: Load a test tube with the same weighing.
6: Close the centrifuge cover.
7: Set the timing.
8: Close the power switch.
9: Adjust the speed control knob to the desired speed.
10: Before each stop, the speed control knob must be set to the “OFF” position in the minimum position “Timer”. Turn off the power switch and turn off the power.
11: Wipe the inner cavity and the rotor and close the centrifuge cover.
Fifth, maintenance:
l: Do not place any objects on the centrifuge cover. After each use, be sure to clean the inner cavity and rotor, and cover the centrifugal cover to prevent dust and dirt from entering.
2: If the centrifuge is not used for a long time, the centrifuge cover should be opened for a period of time before drying again to dry the inner cavity.
3: After the motor's carbon brush is used for 3,000 hours, it should be replaced in time to avoid wearing the commutator.
4: After long-term use of the centrifuge, natural wear is a normal phenomenon.
the performance:
package:1PC
warranty: 120 days
On Sep-19-19 at 20:47:36 PDT, seller added the following information: